![]() Now, to spend some time learning to use MacDoppler. I am using my Maestro as the Flex Client. Power up your RT-21 Controller(s) and let the initializations fully complete. MacDoppler in the upper left, Interface on the upper right, and station controls along the bottom. My next project is to add "spots" to my Maestro showing Satellite Name, Elevation and Azimuth.īelow is a screenshot of my "Mac" based Satellite station. Node-Red will disconnect with PST Rotor after 15 minutes, so I do not track every satellite around the clock and ware out my rotor. From: Subject: MacDoppler v3.8.1 MacDoppler will read in the Keplerian elements (in either format), calculate the position and. I also use the Azimuth and Elevation information from MacDoppler to drive my PST Rotor, interfaced using Node-Red. Node-Red will identify the TX and RX slice, from the "bound" client (for multiplex, two client operations) and assign the down frequency and up frequency accordingly, along with the required operating mode for each. ![]() My interface uses the up/down frequency and modes from MacDoppler to give full doppler correction capability to the Flex Client. By the way, I have been working a lot of Europe on RS-44, so hope to QSO with you in the future. We listen for this stream and convert to. So, Node-Red based MacDoppler interface allows the Flex to follow the uplink and downlink from MacDoppler, but you must use those tiny tiny little knobs in MacDoppler to change the Flex VFO frequency. ![]() So.I built a Node-Red / piFRStack interface between MacDopper and my Flex 6600 server running Multiplex. MacDoppler software outputs a udp stream every second with elevation (altitude) and azumuth of passing satellites. I know it will interface through DogPark Smart SDR, but I want to be able to use other clients, such as my Maestro. I now want to give DogPark MacDoppler a try, but as most know, it will not interface with the Flex Server. I also use FlexSatPC to gain more functionality from my Smart SDR interface. The Windows based Satellite tracking software of choice has been SatPC32. Node-Red for station controls, including antenna and pre-amp switching. Then click the X that appears on the left upper corner of MacDoppler to perform the uninstall. Click and hold MacDoppler icon with your mouse button until it starts to wiggle. Open up Launchpad, and type MacDoppler in the search box on the top. I use my Flex 6600 and Q5 Transverter for Satellites. Option 2: Delete MacDoppler in the Launchpad. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |